Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
9.1. Specifications.
9.2. The general data
9.3. System of compulsory ventilation картера (PCVсистема)
9.4. System рециркуляции (EGR system)
9.5. System доокисления exhaust gases
9.6. System of catching of steams of gasoline (EEC system)
9.7. System of electronic injection of fuel a self-diagnostics mode
9.8. A regulator of a stream of air
9.9. A regulator of pressure of fuel both the solenoidal valve check and replacement
9.10. Gauges of the processor block
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







9-8-regulyator-potoka-vozdukha.html

9.8. A regulator of a stream of air

Removal
1. Disconnect from a regulator a hose (the photo in Gl.4, section 9 see).
2. Disconnect a socket.
3. Turn away bolts and remove a regulator from a soaking up collector.
Check
4. It is independently possible to define pressure presence on a regulator, resistance of a regulator, and also shutter closing at a regulator warming up. If заслонка it is not closed in the presence of pressure and normal resistance a regulator hand over in car-care centre for diagnostics.
5. Remember position of a shutter of a regulator. At temperature 1419 ° About a shutter should block about half of channel. At fall of temperature the shutter opens more.

7.10 Check of pressure on a regulator


6. Submit on a regulator by means of auxiliary wires (in one of them solder in a safety lock) pressure from the battery.
7. At a warming up of a regulator a current from the battery the shutter should block the channel (approximately for 5 mines). In this case the regulator is serviceable, execute operations, since item 10.
8. If the shutter is closed too long check up resistance of a regulator.
9. If resistance differs from norm replace a regulator.
10. Check up pressure on a regulator, having connected the voltmeter between conclusions and and b a socket (photo). Pressure should be nearby 12 In and later 5 сек decreases to 0. Otherwise regulator conducting is faulty.
11. The regulator can not work if there is no connection with weight through the processor block, despite pressure presence on a conclusion "and". Check up integrity of a wire from a regulator to the processor block.
12. Installation is carried out upside-down. Replace a sealing ring.

«The previous page
9.7. System of electronic injection of fuel a self-diagnostics mode
The following page»
9.9. A regulator of pressure of fuel both the solenoidal valve check and replacement