Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
8.1. Specifications
8.2. Ignition system the general data
8.3. System of ignition check
8.4. The distributor removal
8.5. The distributor installation
8.6. The rotation gauge коленвала check
8.7. The coil of ignition removal and installation
8.8. System of start-up of the engine the general data
8.9. System of start-up of the engine check
8.10. A starter removal and installation
8.11. The traction relay removal and installation
8.12. A starter replacement of brushes
8.13. Charge system the general data
8.14. The generator leaving and safety measures
8.15. System of a charge check
8.16. The generator removal and installation
8.17. A regulator of pressure and a brush replacement
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







8-6-datchik-vrashheniya-kolenvala-proverka.html

8.6. The rotation gauge коленвала check

1. Include a self-diagnostics mode (Gl. 6) also check up presence of malfunctions in fuel system.
2. 1 flash of the red indicator specifies in malfunction of a chain of the gauge of rotation коленвала and 1 green (indicators are located on the processor block).
3. Disconnect a socket from the gauge (photo) and include ignition.
4. Check up pressure presence between a conclusion And and weight (photo).
5. Switch off ignition and an ohmmeter check up a chain between conclusion D and weight (photo).
6. If pressure is present also a chain on weight is serviceable, address in car-care centre for check процес the weed block and conducting.

3.5 Drawing of a label on an adjusting bolt


5.3а the  Socket of the gauge of rotation колёнвала on engine K24 1. A socket



«The previous page
8.5. The distributor installation
The following page»
8.7. The coil of ignition removal and installation