8-5-raspredelitel-ustanovka.html
8.5. The distributor installationIf after removal of the distributor position коленвала was not broken
1. Turn бегунок in the position designated before removal of the distributor.
2. Establish the distributor, slightly having turned run нок that the flute on the distributor has entered into gearing with the drive platen
3. If position of the case of the distributor concerning the block did not vary, and fixing apertures have coincided. That the put labels on бегунке and on the distributor case should settle down opposite each other.
4. Tighten bolts of fastening with the set moment.
5. Put a cover and attach wires.
6. Check up ignition installation.
If after removal of the distributor position коленвала has been broken
7. Expose the piston 1 го the cylinder in position ВМТ of a step of compression.
8. Establish on the distributor a cover. Define a place where the wire conclusion 1го the cylinder г settles down designate a label on the distributor case.
9. Uncover, turn бегунок, having arranged it opposite to a label.
10. Put a cover and attach wires
11. Check up ignition installation.
|