Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
8.1. Specifications
8.2. Ignition system the general data
8.3. System of ignition check
8.4. The distributor removal
8.5. The distributor installation
8.6. The rotation gauge коленвала check
8.7. The coil of ignition removal and installation
8.8. System of start-up of the engine the general data
8.9. System of start-up of the engine check
8.10. A starter removal and installation
8.11. The traction relay removal and installation
8.12. A starter replacement of brushes
8.13. Charge system the general data
8.14. The generator leaving and safety measures
8.15. System of a charge check
8.16. The generator removal and installation
8.17. A regulator of pressure and a brush replacement
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







8-3-sistema-zazhiganiya-proverka.html

8.3. System of ignition check

1. If the starter turns коленвал, and the engine is not started, check up survey a condition of wires, свеч, covers of the distributor and бегунка.
2. If all these details in a normal state check up integrity of high-voltage wires. For this purpose switch off ignition, disconnect a wire of the coil from the distributor and fix in 45 mm from the smoothed out site of weight. Having turned a starter the engine watch formation of sparks. In the presence of sparks it is necessary to search for malfunction in other systems of the engine. If the spark is absent, or sparks are observed with faults the further check of system of ignition is necessary.
3. Warm up the engine (if it will be possible to start) and stop.
4. Check up pressure on the battery at switched off ignition and consumers. If pressure more low 11,5 In remove the battery and charge (if the battery did not remain under loading long time check up a charge chain).
5. If pressure on the battery at starter inclusion more low 9,6 In the battery is charged short. Remove the battery and charge.
6. Check up a distributor and wire cover. If at measurement of resistance of a wire of the candle, attached to a distributor cover, the indication of an ohmmeter is less 30 Clod (photo) the conclusion of a cover and a wire are serviceable.

2.7б Check of resistance of isolation 1. A cover


2.8 Check of resistance of a secondary winding, coils of ignition 1. An ohmmeter


7. On cars 19871988 check up resistance of isolation between electrodes covers (photo). If resistance below norm a cover replace.
8. Check up resistance of a secondary winding of the coil of ignition, having connected an ohmmeter at the switched off ignition between high-voltage, a conclusion and conclusion Н coils (photo). If the ohmmeter indication does not correspond to norm the coil replace.

«The previous page
8.2. Ignition system the general data
The following page»
8.4. The distributor removal