8-17-regulyator-napryazheniya-i-shhetki-zamena.html
8.17. A regulator of pressure and a brush replacement1. Remove the generator
2. Turn away 4 coupling bolts on a back cover (photo).
3. Turn away two screws and a nut and remove a cover. Slightly пристукнув, separate a forward cover with a rotor.
4. Turn away 5 nuts on a back cover and remove статор (photo).
5. Check up length of brushes, if necessary replace. Before the soldering put forward a brush on 11 mm and cautiously solder conclusions in the specified places (photo) a loop on the wire end (having turned a wire on 1 coil).
6. For regulator replacement do the following (peгулятор to remove only in need of replacement).
. Disconnect a regulator from the rectifier, for what отпаяйте
Conclusion also remove a rivet (photo). It is recommended at first отпаять wires статора from the rectifier.
. Disconnect a regulator from щеткодержателя for what remove solder and flat-nose pliers pull out pins.
. At installation of a new regulator cautiously (easy blows) запрессуйте pins, пропаяйте all connections and расклепайте, having established a new rivet.
7. Collect and establish the generator upside-down.
|