Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
8.1. Specifications
8.2. Ignition system the general data
8.3. System of ignition check
8.4. The distributor removal
8.5. The distributor installation
8.6. The rotation gauge коленвала check
8.7. The coil of ignition removal and installation
8.8. System of start-up of the engine the general data
8.9. System of start-up of the engine check
8.10. A starter removal and installation
8.11. The traction relay removal and installation
8.12. A starter replacement of brushes
8.13. Charge system the general data
8.14. The generator leaving and safety measures
8.15. System of a charge check
8.16. The generator removal and installation
8.17. A regulator of pressure and a brush replacement
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







8-16-generator-snyatie-i-ustanovka.html

8.16. The generator removal and installation

1. Disconnect the battery from weight. Lift car redock.
2. Designate and disconnect wires from generators
Remove a belt.
3. Turn away an adjusting bolt and a fastening bolt.
4. Get the generator from outside the bottoms.
5. Installation is carried out upside-down.

16.2 Details of the generator (without a back dustproof cover) 1. A coupling bolt 2. A back cover 3. Щеткодержатель 4. The rectifier 5. The case of the forward bearing 6. A rotor 7. A regulator 8. Статор 9. The back bearing 10. The forward bearing 11. A forward cover 12. Шк


16.4 Nuts of fastening статора


16.5а the Arrangement of brushes before the soldering


16.5б Places of the soldering of brushes


16.6 Regulator fastens to the rectifier the soldering () and a rivet ()




«The previous page
8.15. System of a charge check
The following page»
8.17. A regulator of pressure and a brush replacement