Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
7.1. Fuel system - the general data
7.2. The fuel filter - replacement
7.3. Idling turns - check and adjustment
7.4. A fuel highway - repair
7.5. A cable of a drive throttle заслонки - removal and installation
7.6. A pedal - removal and installation
7.7. The fuel pump - check
7.8. The fuel pump - removal and installation
7.9. System of electronic injection of fuel - the general data
7.10. Units of control and measuring system with processor block ECCS - the general data
7.11. Декомпрессия fuel system
7.12. The case throttle заслонки (for systems with preliminary injection ТВI of systems) removal and installation
7.13. An atomizer replacement
7.14. System of injection of fuel – adjustments System of preliminary injection (TBI)
7.15. Fuel system clearing
7.16. A tank removal and installation
7.17. The gauge of level of fuel removal and installation
7.18. A tank washing
7.19. An exhaust system the general data
7.20. A forward exhaust pipe removal and installation
7.21. Katalitichesky нейтрализаторснятие and installation
7.22. The muffler removal and installation
7.23. An average pipe removal and installation
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







7-4-toplivnaya-magistral-remont.html

7.4. A fuel highway - repair

1. In a highway seamless steel tubes (copper and aluminium because of bad виброустойчивости it is forbidden to establish) are established only. At performance of any works with fuel system observe fire prevention rules. Before the beginning of works execute декомпрессию fuel system.
2. If the part of a metal tube it is possible to cut out and replace it with a rubber hose on 1 FROM mm more long a deleted part is damaged only. Both ends of a hose fix collars.
3. If the length of a deleted part of a metal tube exceeds 150 mm for connection it is necessary to use a metal tube with the pieces of hoses put on on the ends. The total length of hoses should not exceed 250 mm.
4. After repair start the engine and be convinced of absence of a leak.

«The previous page
7.3. Idling turns - check and adjustment
The following page»
7.5. A cable of a drive throttle заслонки - removal and installation