Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







6-9-datchik-temperatury-zhidkosti-proverka-i-zamena.html

6.9. The gauge of temperature of a liquid - check and replacement

Check
1. The gauge represents the thermoresistor consistently connected to the index of temperature.
2. The gauge will screw in the right forward corner of a soaking up collector.
3. If the index does not register temperature check up safety locks and a chain. For this purpose disconnect from the gauge a wire and connect to weight. Include ignition and in some seconds switch off. If the arrow of the index has deviated in sector Hot the gauge is faulty. Otherwise the index or a chain is faulty.
4. At temperature 60°С resistance of the gauge 70-90 Ohm, and at 100°S - 24 0м.
Replacement
5. Not cooled down engine merge a liquid and disconnect a wire from the gauge.
6. Screw the gauge and turn new, it is reliable zatja-nita not to use Hermetic.

«The previous page
6.8. The pump of a cooling liquid - removal and installation
The following page»
6.10. Heating system - the general data