Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







6-8-nasos-okhlazhdayushhejj-zhidkosti-snyatie-i-ustanovka.html

6.8. The pump of a cooling liquid - removal and installation

1. Disconnect the battery from weight and lift the car.
2. Merge cooling liquid.
3. Remove the fan with a casing and belts of hinged units.
4. On engines V6: remove a pulley of the pump and a pulley - успокоитель with коленвала, remove covers of a gear belt.
5. Turn away bolts of fastening of the pump (photo).
6. Remove the pump, remove old consolidation.

7.3 Check люфта a pump shaft


8.5б Bolts of fastening of the pump on engines V6


8.7 Details of the pump of a cooling liquid of engine V6
1. For зэднеприводных а/м                                                       
2. A lining                                                                                  
3. For all-wheel drive а/м


7. At assemblage grease a lining герметикой and establish on блек cylinders (photo).
8. Tighten bolts in regular intervals with the set moment.
9. Other operations are carried out in the return of an order. Adjust a tension of belts, wash down a liquid, warm up дригагель and be convinced of absence of a leak. If necessary add a liquid.

«The previous page
6.7. The pump of a cooling liquid - check
The following page»
6.9. The gauge of temperature of a liquid - check and replacement