Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







6-17-kompressor-snyatie-i-ustanovka.html

6.17. The compressor - removal and installation

1. Translate рычажки managements in position of the maximum cooling, open windows and sustain the compressor included on 10 mines idling.

15.5 Adjusting screw of the proof-reader of idling on инжекторном the engine
1. The screw
2. The electromagnetic valve of the proof-reader


16.3 Vlagootdelitel of the conditioner
1. A tube from the condenser
2. A final tube
3. The pressure gauge
4. A collar bolt


2. Disconnect the battery from weight and remove the ignition distributor.
3. Turn away a bolt натяжителя a belt on a compressor pulley, turn an adjusting bolt and remove re-men (photo).
4. Disconnect from the compressor of a tube highways (photo).
5. Disconnect from the compressor all wires. -
6. Turn away bolts and remove the compressor from an arm (photo).
7. Get the compressor from a compartment.

Attention!
In order to avoid breakage working position of the compressor should not be broken for the period of more than 10 minutes If normal position nevertheless has been broken, establish the compressor into position and turn a shaft on some turns.

8. Installation is carried out upside-down. At joining of tubes replace sealing rings. Fill the conditioner in car-care centre.

17.3 Bolt натяжитапя on a compressor pulley () and an adjusting bolt () on engine V6


17.6 Compressor and arm



«The previous page
6.16. Влагоотделитель - removal and installation
The following page»
6.18. The condenser - removal and installation