Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system


6.15. The proof-reader of idling - adjustment

1. Warm up the engine idling.
2. At the disconnected conditioner check up idling turns, if necessary adjust (Gl. 1).
3. Include the conditioner and again check up idling turns (on cars with automatic transmission the selector translate in position N).
Carburettor engines
4. Idling turns should be on zadnepri-water cars of 800 rpm, on all-wheel drive-950 rpm. Otherwise adjust screw rotation on the lever of the accelerating pump (photo), the screw of adjustment of idling not to touch.
Inzhektornye engines
5. Establish turns of idling  of 800 950 rpm rotation of the adjusting screw (photo).
6. Some times press a pedal throttle заслонки and be convinced that idling turns correspond to norm with the switched off and included conditioner.

«The previous page
6.14. A central air - service
The following page»
6.16. Влагоотделитель - removal and installation