Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







6-12-radiator-otopitelya-snyatie-i-ustanovka.html

6.12. A heater radiator - removal and installation

1. Merge cooling liquid.
2. On cars with the conditioner disconnect shlz-ngi on a partition of a motor compartment (photo)
3. On cars without the conditioner remove a casing of a radiator (photo) and disconnect hoses on a partition of a motor compartment.
4. Remove the central section (if it is provided).
5. Disconnect from a casing of the fan a cable делительной заслонки.
6. On cars with the conditioner remove the fan, turn away a nut and bolts of the block of cooling.
7. Turn away screws and having raised, remove a heater.
8. Remove the control panel (see more low).
9. If necessary disassemble a heater for what disconnect draughts of the lever mixing and делительной заслонок, remove latches and disunite both half of casing (photo). At installation adjust draughts (see more low).

11.3б the Fan is established on the right under перчаточным a box
1. A socket
2. A bolt
3. A hose


12.2 Hoses of a heater


12.3 Details of a heater and the conditioner
1,2,13. A defreezing nozzle
3. A casing
4. An air inlet
5,8. An air line
6. Nozzles for salon heating
7. The bottom air line of the conditioner
8. Отопитепь  
10,12. An arm
11. The conditioner


12.9 Radiators of a heater and casing
1. Mixing заслонка  
2. The drainage crane
3. Делительная заслонка
4. Заслонка a ventilating nozzle
5. A radiator



«The previous page
6.11. The fan - removal and installation
The following page»
6.13. A central air - the general data