Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
6.1. Cooling system - the general data
6.2. Antifreeze - the general data
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and муфта - removal and installation
6.6. A tank - removal and
6.7. The pump of a cooling liquid - check
6.8. The pump of a cooling liquid - removal and installation
6.9. The gauge of temperature of a liquid - check and replacement
6.10. Heating system - the general data
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. A central air - the general data
6.14. A central air - service
6.15. The proof-reader of idling - adjustment
6.16. Влагоотделитель - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







6-1-sistema-okhlazhdeniya-obshhie-svedeniya.html

6.1. Cooling system - the general data

The pump, the thermostat, broad tank and hoses (photo) concern cooling system a radiator with a safety valve.
Liquid circulation in the engine is provided with the centrifugal pump mounted in a forward part of the block of cylinders. With a nagretoj liquid are warmed the case заслонки and a soaking up collector. On cars with automatic transmission in the bottom part of a radiator the cooler трансмиссионной liquids is mounted. On cars with the conditioner before a radiator the condenser is established. Крыльчатка the cooling fan has a drive from hydraulic муфты. On a part of cars in муфту the temperature regulator is built in, i.e. the fan joins after engine warming up when крыльчатка it is entered into gearing with shaft by means of a thermobimetallic spiral spring. Муфта not folding, care it it is not required.

1.2 System of cooling of 4-cylinder engines
1. The thermostat  
2. From a heater
3. To a heater
4. The case заслонки
5. The thermostat valve


3.5 Correct position of the thermostat at installation


3.9 Thermostat is established so that the ventilating valve (1) or the vibrating valve (2) have been turned upwards.


3.14 Thermostat of engine V6



«The previous page
6. Systems of cooling, heating, ventilation and air-conditioning
The following page»
6.2. Antifreeze - the general data