Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
5.1. The general data
5.2. Compression check in engine cylinders
5.3. Dismantle of the power unit - security measures
5.4. The engine - removal and installation
5.5. Engine major repairs - the general data
5.6. Engine restoration - alternatives
5.7. Engine major repairs - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. A head of the block of cylinders-clearings and condition check
5.10. A head of cylinders - assemblage
5.11. Shatunno-piston group-dismantle
5.12. Коленвал - dismantle
5.13. The block of cylinders - clearing
5.14. The block of cylinders - condition check
5.15. Rods and pistons - condition check
5.16. Kolenval - condition check
5.17. Radical and шатунные bearings - check and selection
5.18. Engine-assembly order major repairs
5.19. Piston rings - installation
5.20. Kolenval - installation and check of backlashes of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of backlashes in шатунных bearings
5.23. Start-up of the engine after repair and обкатка
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system


5.4. The engine - removal and installation

1. On cars with the formula 4x2 the engine acts in film together with a check point. On cars with the formula 4x4 the check point (transmission) is disconnected from the engine, fixed and remains on the car.
2. Remove a cowl, the air filter and the battery.
3. Merge a liquid and oil from the engine and a check point.
4. Disconnect radiator hoses, designate and disconnect all vacuum hoses and wires.
5. Disconnect and muffle fuel hoses. Remove the pump of the hydraulic booster and the compressor, take aside, without disconnecting from highways.
6. Disconnect a cable throttle заслонки.
7. Disconnect heater hoses, remove an arm of the pneumovalve from a partition of a motor compartment.
8. Lift a forward part of the car and disconnect wires from a starter and the generator. On engines V6 remove a starter.
9. On cars with automatic transmission disconnect hoses from a cooler in the bottom part of a radiator and merge a liquid.
10. Remove a radiator and a casing.
11. Disconnect an exhaust pipe from a collector.
12. Remove from transmission the working cylinder of coupling, disconnect a cable of a manual brake and take aside.
13. On cars 4x4: disconnect forward карданный a shaft and semiaxes (Gl. 9), turn away 5 bolts and lower a forward reducer on a cross-beam, disconnect transmission from the engine (or turn away hydrotransformer bolts) (Gl. 7).
14. On cars 4x2: disconnect карданный a shaft (Gl. 9), will perform all works on a transmission detachment, to отворачивания bolts (Gl. 7).
15. Attach таль to hooks on a head of cylinders and will hang out the engine.
16. On cars 4x4 turn away bolts of fastening of a back support of a reducer to a frame.
17. On cars 4x2 turn away bolts of fastening of an arm of transmission to a body, then oтверните bolts of fastening of an arm to transmission.
18. Turn away bolts of fastening of an arm of a forward support to the block of cylinders.
20. On cars 4x4 raise the engine and displace forward to disconnect from transmission. On cars 4x2 incline the engine and get from a motor compartment (photo).
21. For a detachment of automatic transmission on cars 4x2:
Remove the bottom cover.
Turn out hydrotransformer bolts. Remove transmission.

4.20 Dismantle of the engine

22. For a manual transmission detachment on cars 4x2:
Turn away bolts картера couplings. Remove a check point, without supposing that its weight was perceived by primary shaft.
23. Installation is carried out upside-down. On cars 4x4 grease картер couplings by hermetic.

«The previous page
5.3. Dismantle of the power unit - security measures
The following page»
5.5. Engine major repairs - the general data