Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
5.1. The general data
5.2. Compression check in engine cylinders
5.3. Dismantle of the power unit - security measures
5.4. The engine - removal and installation
5.5. Engine major repairs - the general data
5.6. Engine restoration - alternatives
5.7. Engine major repairs - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. A head of the block of cylinders-clearings and condition check
5.10. A head of cylinders - assemblage
5.11. Shatunno-piston group-dismantle
5.12. Коленвал - dismantle
5.13. The block of cylinders - clearing
5.14. The block of cylinders - condition check
5.15. Rods and pistons - condition check
5.16. Kolenval - condition check
5.17. Radical and шатунные bearings - check and selection
5.18. Engine-assembly order major repairs
5.19. Piston rings - installation
5.20. Kolenval - installation and check of backlashes of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of backlashes in шатунных bearings
5.23. Start-up of the engine after repair and обкатка
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







5-21-zadnijj-salnik-ustanovka.html

5.21. A back epiploon - installation

On 4-cylinder engines
1. Grease an epiploon, dress on коленвал and it is cautious запрессуйте оправкой or easy blows under the soft prorate.
On engines V6
2. Make a mark of landing of an old epiploon on depth and remove an epiploon from the holder (photo).
3. Clear an epiploon and grease an external edge. Запрессуйте an epiploon оправкой, or through two wooden бруска, having clamped an epiploon between брусками in a vice. It is possible also запрессовать hammer blows through брусок (photo). The epiploon should come in the holder without warps.

20.13 Installation of a lateral sealant on 4-cylinder engines


4. Grease working edges of an epiploon and establish the holder on a new lining, having greased a platform under the holder hermetic (photo). Tighten bolts.

21.2 Vypressovyvanie of an old epiploon


21.3 Zapressovka of an epiploon in the holder


21.4а Greasing of working edges of an epiploon.


21.4б Greasing platform hermetic under the holder



«The previous page
5.20. Kolenval - installation and check of backlashes of radical bearings
The following page»
5.22. Rods and pistons - installation and check of backlashes in шатунных bearings