5-16-kolenval-proverka-sostoyaniya.html
5.16. Kolenval - condition check1. Wash out a cranked shaft solvent and dry, clean oil channels, necks and remove agnails (photo).
2. Check up a condition of necks of a shaft. Measure diameter of necks in several places and define конусность and ovality (photo). Check up palpation коленвала having established in prisms.
3. In the presence of damages on shaft necks and also if ovality, конусность and deterioration of necks the established limits exceed, the shaft follows перешлифовать and to replace radical and шатунные bearings repair.
4. If on necks under epiploons the deep flute of development from a working edge of an epiploon was formed, there are scratches or other damages коленвал it is recommended to replace.
|
16.1 Remove agnails from edge of a lubricant aperture
|
|
15.8 Measurement of a backlash between a flute and a new ring
|
|
15.9 Measurement of diameter of the piston. Diameter is measured perpendicularly axes of a finger of 1.20,3 mm
|
|
16.2 measurement of diameter of necks коленвала
|
|
17.4а Places of drawing of numbers of dimensional groups of radical bearings on 4-cylinder engines
1. To a forward part of the engine
2. Group In
3. Dimensional group of radical necks
|
|