Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
5.1. The general data
5.2. Compression check in engine cylinders
5.3. Dismantle of the power unit - security measures
5.4. The engine - removal and installation
5.5. Engine major repairs - the general data
5.6. Engine restoration - alternatives
5.7. Engine major repairs - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. A head of the block of cylinders-clearings and condition check
5.10. A head of cylinders - assemblage
5.11. Shatunno-piston group-dismantle
5.12. Коленвал - dismantle
5.13. The block of cylinders - clearing
5.14. The block of cylinders - condition check
5.15. Rods and pistons - condition check
5.16. Kolenval - condition check
5.17. Radical and шатунные bearings - check and selection
5.18. Engine-assembly order major repairs
5.19. Piston rings - installation
5.20. Kolenval - installation and check of backlashes of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of backlashes in шатунных bearings
5.23. Start-up of the engine after repair and обкатка
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







5-14-blok-cilindrov-proverka-sostoyaniya.html

5.14. The block of cylinders - condition check

1. At detection of outer defects (cracks and having chopped off), repair the block or replace. It is recommended to check up presence of Internal defects in the block of cylinders for what it is necessary to hand over the block in a car-care centre workshop.
2. Check up ovality and конусность cylinders, having measured diameter in three planes, in directions parallel and perpendicular axes of the block (photo). If results differ from standard it is necessary to hand over the block in a repair workshop. After block restoration pistons and rings of the repair sizes will be necessary.
3. If a condition of cylinders comprehensible, deterioration of the cylinder and a backlash between the cylinder and the piston do not exceed the established norms cylinders it is required othon-ningovat (photo). Works are recommended to be carried out in car-care centre.
4. Check up deformation of a demountable plane of the block of cylinders (photo). If the deviation from a plane exceeds norm the block follows прошлифовать in a car-care centre workshop. The thickness of a material removed from the block should not exceed a thickness of the material removed from a head. If the total size for which have decreased the block иголовка after polishing exceeds 0,2 mm it is necessary to replace a head and the block.

14.3б the Approximate kind of a surface of the cylinder after хоннингования


14.4а Check of deformation of a demountable plane of the block of cylinders


In this case new pistons steal up on marks on the block of cylinders (photo).

«The previous page
5.13. The block of cylinders - clearing
The following page»
5.15. Rods and pistons - condition check