5-13-blok-cilindrov-ochistka.html
5.13. The block of cylinders - clearing
Attention!
If заглушки channels of system of cooling fail in the channel of the block of cylinders to take them, as a rule, it is impossible.
|
1. Drill in заглушках apertures and pull out, having wrapped bolts or саморезы, or get a stripper with the bent pads.
2. Cautiously clear the block of the rests consolidations (photo).
3. Remove covers of radical bearings and get bearings from the block of cylinders and covers. Designate all details that them not to mix.
4. Clean all channels a stream of steam and compressed air (it is recommended to carry out in car-care centre), wash out the block outside a washing-up liquid. Banish all carving apertures, clean and blow compressed air (photo). Dry the block and grease the processed surfaces веретенным with oil.
|
12.3 Removal of covers on 4 - cylinder engines
|
|
13.4 Prorace of a carving aperture
|
5. Establish covers of radical bearings, bolts tighten by hand.
|
13.6 Zapressovka заглушки
|
|
14.2а Measure diameter of the cylinder under fillets (), in the centre () and in the bottom part ()
|
|
14.2в Measurement of diameter of the cylinder
|
|
14.3а the Brush for хоннингования cylinders
|
|
14.2б Telescopic нутромер for measurement of internal diameter
|
6. Запрессуйте new заглушки without warps, preliminary having greased with their hermetic RTV (photo).
|