Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
5.1. The general data
5.2. Compression check in engine cylinders
5.3. Dismantle of the power unit - security measures
5.4. The engine - removal and installation
5.5. Engine major repairs - the general data
5.6. Engine restoration - alternatives
5.7. Engine major repairs - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. A head of the block of cylinders-clearings and condition check
5.10. A head of cylinders - assemblage
5.11. Shatunno-piston group-dismantle
5.12. Коленвал - dismantle
5.13. The block of cylinders - clearing
5.14. The block of cylinders - condition check
5.15. Rods and pistons - condition check
5.16. Kolenval - condition check
5.17. Radical and шатунные bearings - check and selection
5.18. Engine-assembly order major repairs
5.19. Piston rings - installation
5.20. Kolenval - installation and check of backlashes of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of backlashes in шатунных bearings
5.23. Start-up of the engine after repair and обкатка
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







5-11-shatunno-porshnevaya-gruppa-demontazh.html

5.11. Shatunno-piston group-dismantle

Attention!
Before removal of pistons and rods remove a head of cylinders, the oil pallet and the oil pump.

1. Remove a fillet in the top part of the cylinder (photo).
2. Turn the engine and check up axial люфт rods (photo), inserting щупы between коленвалом and a rod. Axial люфт it will be equal to a total thickness щупов at which люфт disappears. If axial люфт a rod exceeds standard value it is necessary to replace a rod. If new rods are established (or to-lenval) axial люфт can be less norms (in this case it is necessary прошлифовать rods, if necessary consult in a car-care centre workshop). Repeat procedure for other rods.

11.2 Checking axial люфта a rod


11.4а Dress on bolts pieces of hoses.


3. In the absence of labels on rods and covers of rods накерните on  them number of the corresponding cylinder (photo).
4. Ослабьте an inhaling of nuts of covers, turning on them on 1/2 turns at one time, until then while nuts not begin to turn away by hand. Uncover a rod of the first cylinder together with the loose leaf, the loose leaf from a cover do not take. Push out the piston with a rod and the loose leaf through the top part of the cylinder, preliminary having dressed on bolts pieces of hoses (photo).
5. Repeat procedure for all other cylinders.
6. Collect rods with covers, tighten nuts of covers by hand.

«The previous page
5.10. A head of cylinders - assemblage
The following page»
5.12. Коленвал - dismantle