Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
4.1. The general data
4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
4.4. Covers of heads of cylinders – removed and installation
4.5. The platen with коромыслами - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - успокоитель - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon коленвала - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details клапанного the mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







4-5-valik-s-koromyslami-snyatie-i-ustanovka.html

4.5. The platen with коромыслами - removal and installation

1. Uncover heads of cylinders.
2. In 2-3 receptions release platen bolts коромысел, is perfectly in order from the end to the middle. Keep in mind that some the valve are opened and коромысла are under the pressure of springs. Therefore release bolts gradually, otherwise the platen is deformed (photo).

5.2 Bolts of the platen коромысел


5.4 Removal of the platen with коромыслами. The Procedure for test of details is described more low.


6.2 Fixing of hydropushers


6.3 Removal of the case from hydropushers


3. Turn out bolts and store in an order their installations (photo).
4. Remove the platen with коромыслами (photo).
5. Installation is carried out upside-down. Tighten bolts in regular intervals with the set moment, is perfectly in order from periphery to the middle.

«The previous page
4.4. Covers of heads of cylinders – removed and installation
The following page»
4.6. Hydropushers - removal and installation