> Kinds of the repair work which is carried out without dismantle of the engine from the car. Nissan Terrano II (with 1985 on 1999 of release)
Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
4.1. The general data
4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
4.4. Covers of heads of cylinders – removed and installation
4.5. The platen with коромыслами - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - успокоитель - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon коленвала - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details клапанного the mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







4-2-vidy-remontnykh-rabot-vypolnyaemykh-bez-demontazha-dvigatelya-s-avtomobilya.html

4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car

Without dismantle it is possible to replace linings of soaking up and final collectors, a lining of the oil pallet, a head of the block of cylinders, epiploons of a cranked shaft. It is possible to remove such units as soaking up and final collectors, the oil pallet, the oil pump, the pump of a cooling liquid, a starter, the generator, the distributor of ignition, a mechanism detail timing, units of fuel system and a head of the block of cylinders. In extreme cases when there is no necessary equipment, without engine removal it is possible to replace piston rings, pistons, rods and шатунные loose leaves. However, to perform these works without dismantle and full dismantling of the engine extremely it is not recommended, as are required clearing of accompanying details, and also carrying out of preparatory measures on assemblage.

«The previous page
4.1. The general data
The following page»
4.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.