Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
4.1. The general data
4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
4.4. Covers of heads of cylinders – removed and installation
4.5. The platen with коромыслами - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - успокоитель - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon коленвала - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details клапанного the mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







4-16-maslyanyjj-poddon-snyatie-i-ustanovka.html

4.16. The oil pallet - removal and installation

1. Disconnect the battery from weight.

15.86 Measurement of diameter of an aperture in коромысле.


15.6б... And apertures under a pusher in the case I


15.8а Diameter of the platen is measured in the location коромысла


2. Lift a forward part of the car and establish on supports.
3. Remove a guard картера and merge oil.
4. Remove a starter.
5. Remove скобы fastenings колоколообразного картера to the engine.
6. Remove the pendular lever.
7. On cars 4x2 remove arms of the stabilizer of stability.
8. On cars 4x2 remove a stretcher.
9. On cars 4x4 remove an arm of reday of a reducer.

16.17а Put hermetic in places прилегания the holder of a back epiploon and the oil pump   


16.17б Places of drawing of hermetic on a pallet lining
1. A lining


17.3а Bolts of the oil pump


10. Remove transmission support.
11. Disconnect from collectors exhaust pipes.
12. Will hang out the power unit on тали or establish under it a jack.
13. Turn away bolts of fastening of support of the engine to a frame.
14. Raise the engine a little, being careful.
15. Turn away bolts and remove the pallet.
16. Carefully clear demountable planes of the block of cylinders and the pallet of the consolidation rests. Banish and clear carving apertures in the block of cylinders.
17. Put on demountable planes hermetic (photo).
18. Establish a lining on the pallet, establish the pallet and in regular intervals in a cross order tighten bolts with the set moment (photo).

«The previous page
4.15. Details клапанного the mechanism - check
The following page»
4.17. The oil pump - removal, check and installation