Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
4.1. The general data
4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
4.4. Covers of heads of cylinders – removed and installation
4.5. The platen with коромыслами - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - успокоитель - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon коленвала - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details клапанного the mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







4-1-obshhie-svedeniya.html

4.1. The general data

In this Part kinds of works on repair of engines V6 which are carried out directly on the car are described. In all described more low operations on repair it is meant that the engine is established on the car.
The engine has V - a figurative arrangement of cylinders and 2 heads (on one on 3 cylinders), located at an angle 60 °. Both cam-shafts (on one in each head) have a drive from a gear belt. Adjustment of a tension of a belt is provided подпружиненным with a roller with the clown. Transfer of effort from a cam-shaft on the valve is provided through коромысла, established on platens, and hydropushers. Valves self-regulated. On each cylinder it is provided 1 inlet the valve and 1 final. Коленвал it is cast from malleable cast iron. Covers of radical bearings коленвала are cast in a uniform skeleton which fastens to картеру коленвала (to the block of cylinders). The ignition distributor has a drive from the spiral gear wheel dressed on a sock of the left cam-shaft. The leading gear wheel of the oil pump is dressed on a sock коленвала.

«The previous page
4. Engines VS
The following page»
4.2. Kinds of the repair work which is carried out without dismantle of the engine from the car