Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-9-pruzhiny-klapanov-i-maslosemnye-kolpachki-zamena.html

3.9. Springs of valves and маслосъемные caps - replacement

1. Uncover heads of cylinders and platens with коромыслами.
2. Turn out candles (on one on the cylinder).
3. Establish the piston of 1st cylinder in ВМТ a compression step. Change springs and caps in an engine operating procedure (1-3-4-2).
4. Fix the valve, having submitted compressed air or soft flexible прутком (photo). If compressed air leaves the cylinder the head should be removed and repaired.

9.4 Fixing of the valve by the compressed air at spring removal...


9.5... And crackers


5. Compress a spring and remove crackers (photo).
6. Remove a plate, a spring and a cap.
7. Wrap up a core of the valve a tape and get пруток.
8. Check up a condition of a core the valve. Check up a core bend, having turned the valve.
9. Check up freedom of moving of the valve in the plug. At jamming of the valve the head of cylinders should be removed and repaired.
10. Again fix the valve.
11. Grease a core of the valve and dress a cap.
12. Establish springs dense навивкой towards a head of cylinders, establish plates.
13. Compress a spring and establish crackers.
14. Get from the cylinder пруток.
15. Repeat operations for other valves.
16. Further assemblage is carried out upside-down.

«The previous page
3.8. A cam-shaft, support and коромысла - check
The following page»
3.10. A soaking up collector - removal and installation