Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-4-kryshka-golovki-cilindrov-snyatie-i-ustanovka.html

3.4. A cover of a head of cylinders - removal and installation

1. Remove the air filter.
2. Disconnect from свеч wires and take aside together with arms.
3. Disconnect a hose of the vacuum amplifier.
4. Turn away bolts covers (photo).
5. Uncover, cautiously having opened consolidation.
6. Clear a cover of the rests of consolidations.

4.4 Cover of a head of cylinders


4.9 Order of an inhaling of a cover of a head of cylinders on engine KS4: at 1st stage tighten bolts 1 and 2 with the moment 3 Н.м., then tighten all bolts with the moment 6,5-9 Н.м. In that order


7. Put hermetic on demountable planes of a cover and a head of cylinders, "leading round" hermetic bolts from the inside.
8. Establish a lining, a cover and tighten bolts with the set moment. In regular intervals tighten nuts in three - four receptions with the set moment (photo).
9. Other procedures are carried out upside-down.

«The previous page
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
The following page»
3.5. The platen with коромыслами - removal and installation