Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system


3.22. A back epiploon - replacement

1. It is possible to replace an epiploon without removing the pallet and коленвала.
2. Remove transmission (Gl. 7).

21.4 Flywheels and leading disk of the hydrotransformer
1. A flywheel
2. An intensifying plate

3. Remove coupling.
4. Remove a flywheel or a leading disk of the hydrotransformer.
5. Hook and cautiously get an epiploon.
6. Check up a condition of a condensed neck коленвала. At detection on a neck of deep development and other defects коленвал replace.
7. Oil an epiploon for the engine, working edges grease молибденовой with greasing.
8. Dress an epiploon and it is cautious запрессуйте hammer blows under the prorate.
9. Establish a flywheel or a leading disk of the hydrotransformer.
10. Establish coupling and an intensifying plate.
11. Establish transmission.

«The previous page
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
The following page»
3.23. Engine support - replacement