3-20-maslyanyjj-poddon-snyatie-i-ustanovka.html
3.20. The oil pallet - removal and installation1. Merge oil.
2. Lift a forward part of the car and establish on supports.
3. Remove engine mudguards.
4. On cars with the formula 4x9 remove a stretcher.
5. On cars with the formula 4x4 remove a forward reducer, will hang out the engine, having weakened support. Fix support wooden брусками.
6. Turn away bolts and remove the oil pallet. At removal do not damage demountable planes of the block of cylinders and the pallet.
|
19.14в On engine K24 the link with silvery colouring should be combined with a label on a cam-shaft asterisk
|
|
19.15а take aside успокоитель.
|
|
19.15б the Backlash between the case натяжителя and a boot after assemblage should be absent
1. Натяжитель
2. After assemblage
|
|
21.2 Removal of a flywheel
|
7. Carefully clear demountable planes of the block of cylinders and the pallet of the consolidation rests. Wash out condensed planes solvent of varnishes or acetone. Be convinced of cleanliness of carving apertures in the block of cylinders.
8. Check up presence on a demountable plane of the pallet of deformations, especially about apertures under bolts. If necessary отрихтуйте a demountable plane a hammer, having laid on a wooden board.
9. Put on a plane of the pallet hermetic RTV a thin layer and lay a lining.
10. Establish the pallet and in regular intervals in a cross order tighten bolts with set, the moment. Through 30 mines (after схватывания hermetic) fill in oil, start the engine and be convinced of absence of leaks.
|