Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-2-vidy-remontnykh-rabot-vypolnyaemykh-bez-demontazha-dvigatelya-s-avtomobilya.html

3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car

Without dismantle it is possible to replace linings of soaking up and final collectors, a lining of the oil pallet, a head of the block of cylinders, epiploons of a cranked shaft. It is possible to remove such units as soaking up and final collectors, the oil pallet, the oil pump, the pump of a cooling liquid, a starter, the generator, the distributor of ignition, a mechanism detail timing, units of fuel system and a head of the block of cylinders. In extreme cases when there is no necessary equipment, without engine removal it is possible to replace piston rings, pistons, rods and шатунные loose leaves. However, to perform these works without dismantle and full dismantling of the engine extremely it is not recommended, as are required clearing of accompanying details, and also carrying out of preparatory measures on assemblage.

«The previous page
3.1. The general data
The following page»
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.