Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-18-perednyaya-kryshka-snyatie-i-ustanovka.html

3.18. A forward cover - removal and installation

1. Merge cooling liquid.
2. Remove the fan and a radiator.
3. Merge oil.
4. Remove the  ignition distributor.
5. Remove the oil pump.
6. Remove the pump of a cooling liquid.
7. Remove the lever of adjustment of a tension of a belt of the generator for what turn away the top bolt of the generator, and then lever bolts.
8. Disconnect from a forward cover vacuum and fuel tubes.
9. Remove the conditioner compressor (if it is provided) and take aside, without disconnecting from a highway.
10. Remove the hydraulic booster pump  (if  it is provided) and take aside, disconnect from the pump hoses.
11. Remove an inlet branch pipe of a cooling liquid.
12. Remove the oil pallet.
13. Remove a pulley коленвала.
14. Turn away bolts and remove a forward cover, having displaced easy blows (photo).
15. Запрессуйте a new epiploon.
16. Lay on a cover a lining and put hermetic in the specified points (photo).
17. Grease a forward edge of an epiploon. Establish a cover and in regular intervals in stages tighten bolts with the set moment.

18.16 Places of drawing of hermetic before cover installation


18. Other operations on assemblage are carried out upside-down.

«The previous page
3.17. A forward epiploon коленвала - replacement
The following page»
3.19. A chain and asterisks - removal and installation