Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system


3.17. A forward epiploon коленвала - replacement

17. A forward epiploon коленвала - replacement
1. Remove a pulley.
2. Cautiously get an epiploon, having hooked its screw-driver or other tool (photo).
3. Clear an aperture under an epiploon and slightly oil an external surface of a new epiploon for the engine. Cautiously запрессуйте a new epiploon into place with the help оправки with a diameter a bit smaller than diameter of an epiploon (photo). After installation be convinced that position of a spring of an epiploon is not broken.
4. Establish a pulley.
5. Establish other details. Start the engine and be convinced of absence of a leak.

17.2 Forward epiploon коленвала

17.3 Zapressovka of an epiploon

18.14а At removal of a cover do not damage a forward part of a lining of a head of cylinders

18.14б the Forward cover of engine K24
1. Коленвал
2. An asterisk коленвала
3. Маслоотражатель
4. A pulley
5. An epiploon
6. A cover
7. A boot натяжителя and успокоитель chains
8. Натяжитель
9. An asterisk
10. A chain

«The previous page
3.16. A pulley коленвала - removal and installation
The following page»
3.18. A forward cover - removal and installation