Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-16-shkiv-kolenvala-snyatie-i-ustanovka.html

3.16. A pulley коленвала - removal and installation

1. Disconnect the battery from weight.
2. Remove a radiator with a casing.

15.4 Check of a backlash in gearing of gear wheels (1), a backlash between a conducted gear wheel and the case of the pump (2), axial люфта (3) and deformations of a plane of the case (4)


16.6 Removal of a pulley коленвала


3. Remove the bottom forward cover.
4. Remove belts.
5. Turn away a pulley bolt, having included transfer or zafi-ksirovav a flywheel (on а/м with automatic transmission).
6. Remove a pulley by means of a stripper (photo).
7. Installation is carried out upside-down. Oil an aperture of a pulley for the engine. All bolts tighten with the set moments.

«The previous page
3.15. The oil pump - check
The following page»
3.17. A forward epiploon коленвала - replacement