Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-14-maslyanyjj-nasos-snyatie-i-ustanovka.html

3.14. The oil pump - removal and installation

1. Establish the piston of 1 th cylinder in ВМТ a compression step.
2. Uncover the distributor of ignition and обо4 mean position бегунка concerning the distributor case.
3. Lift a forward part of the car and establish on supports.
4. Remove engine mudguards.
5. Merge oil from the engine.
6. On cars with the formula 4x4 establish a support under a forward reducer.
7. Turn away bolts and remove the pump in gathering with shaft.
8. The order of dismantling of the pump is described in more low.
9. Be convinced that the piston of 1st cylinder is in ВМТ a compression step.
10. Fill the pump with oil, combine a label навалу) the pump with a lubricant aperture under a leading gear wheel (photo).
11. Establish a lining and the pump.
12. Tighten bolts and check up orientation of a shaft coca. If necessary repeat operation устаноааЩ
13. Fill in oil. Check up ignition installation

14.10 At installation of the pump the label on a shaft should be opposite to a lubricant aperture of the pump


15.1 Details of the oil pump
1, the Shaft
2,4 Lining
3. The case
5. Gear wheels (conducting and conducted)
6. A cover
7. Заглушка
8. A washer
9. A spring
10. The valve
11. The reduktsionnyj valve


«The previous page
3.13. A head of cylinders - installation
The following page»
3.15. The oil pump - check