3-13-golovka-cilindrov-ustanovka.html
3.13. A head of cylinders - installation1. Before installation carefully clear demountable surfaces of a head and the block of cylinders. Соскребите a deposit and the rests of a material of a lining, wash out solvent.
2. Check up presence on demountable planes of a head and the block of cylinders задиров, having chopped off, hollows and other damages. Insignificant damages can be eliminated надфилем, in the presence of serious damages the head or the block are subject to repolishing.
3. Accurately banish carvings of bolts and in apertures under bolts.
4. Put a new lining on the block of cylinders, focusing on pins. Cautiously put a head on the block of cylinders, without breaking lining position.
5. Wrap by hand bolts of a head of cylinders on former places.
6. Tighten bolts with the set moment in the specified sequence (photo), doing 1/4 turns at one time. The inhaling order is specified in Specifications.
7. Establish a cam-shaft asterisk.
8. Other operations on assemblage are carried out upside-down.
9. After the termination of works fill system of cooling with a liquid, start the engine, check up leak presence. Check up idling turns, if necessary adjust.
|
13.6 Sequence of an inhaling of bolts of a head of cylinders (К24)
|
10. Adjust valves, having established backlashes for the heated-up engine.
|