Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
3.1. The general data
3.2. Kinds of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of 1st cylinder in ВМТ a compression step.
3.4. A cover of a head of cylinders - removal and installation
3.5. The platen with коромыслами - removal and installation
3.6. The platen with коромыслами - dismantling and assemblage
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and коромысла - check
3.9. Springs of valves and маслосъемные caps - replacement
3.10. A soaking up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A pulley коленвала - removal and installation
3.17. A forward epiploon коленвала - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







3-12-golovka-cilindrov-snyatie.html

3.12. A head of cylinders - removal

1. Merge cooling liquid.
2. Remove the air filter.
3. Remove the pump of the hydraulic booster and a roller натяжителя a pump belt (if are provided).
4. Disconnect from свеч wires and take aside together with arms.
5. Disconnect a tube эжекции air, remove the valve case (if it is provided).
6. Remove soaking up collector.
7. From a partition of a motor compartment remove the thermovacuum distributor with an arm.
8. Disconnect a tube рециркуляции.
9. Remove the fuel pump (mechanical).
10. Remove a final collector.
11. Uncover heads of cylinders.
12. Establish the piston of 1st cylinder in ВМТ a step of compression and remove a cam-shaft asterisk (see above).
13. Release 10 bolts of a head of cylinders, turning on each bolt on 1/4 a turn at one time. Release bolts in the specified sequence (photo). Turn out bolts and store in cash desk in that order in which they have been wrapped.
14. Turn away two small bolts of fastening of a forward cover.
15. Displace a head, easy blows through the wooden prorate and remove.
16. Remove a lining.
17. The technique of check of a head is described in the Part With.

«The previous page
3.11. A final collector - removal and installation
The following page»
3.13. A head of cylinders - installation