2-45-proverka-i-ustanovka-momenta-zazhiganiya.html
2.45. Check and installation of the moment of ignition.
Attention!
On engines after 1990 the ignition moment is regulated by automatically processor block.
|
|
45.4 Marks in a pulley and scale for ignition installation on 4-cylinder engines
|
|
45.2 Marks in a pulley and scale for installation for жигания on 4-cylinder engines
|
1. At check of a corner of installation of ignition be guided by the data in the tablet strengthened with внутрей of the party of a cowl.
2. On 4-cylinder engines the ignition moment is checked on combination of a mark in a pulley коленвал with division of the scale mounted over a pulley (photo) the Label 0 corresponds ВМТ.
3. Designate a mark in a pulley a light paint
4. On engine V6 the moment of ignition the scale is checked on combination of the motionless index with division into a scale put on a pulley успокоителя (photo).
5. Check up idling turns, if necessary adjust. Connect a stroboscope according to the instruction of the manufacturer.
6. Warm up the engine, stop and disconnect devices which are specified in подкапотной to the tablet for the given engine
7. Attach a stroboscope according to the instruction from готовителя.
8. Start the engine, 2-3 times press a pedal of gas and translate in an idling mode.
9. Direct stroboscope light on a pulley коленвала the Shined label should be opposite to corresponding division of a scale.
|
45.11 Installation of ignition 1. Increase in a corner of an advancing 2. Corner reduction
|
10. In need of adjustment release adjusting bolts of the distributor.
11. For ignition installation turn the case of the distributor before combination of a label with the necessary division scales (photo). Tighten bolts and again check up ignition installation.
12. Disconnect a stroboscope and check up idling turns, if necessary adjust.
13. If at a trip sonorous knocks at car movement on lifting are listened or at dispersals again attach a stroboscope and reduce an advancing corner on 1-2 °.
|