Nissan Terrano 2 with 1985 on 1999
	1. The maintenance instruction and to maintenance service
	2. Car maintenance service
		2.1. Introduction
		2.2. Maintenance service terms
		2.3. An order of performance of adjustments - broad-brush observations
		2.4. Check of level of liquids
		2.5. Check of level of a liquid in automatic transmission
		2.6. Check of level of a liquid of the hydraulic booster of a wheel
		2.7. Check of tyres (through each 400 kilometres or weekly)
		2.8. Care of the battery
		2.9. Care of cooling system
		2.10. Check of brushes of screen wipers
		2.11. Check of a condition of the hoses located in a motor compartment.
		2.12. Check and adjustment of a pedal of a brake
		2.13. Replacement of oil and the oil filter
		2.14. Check and adjustment of backlashes of valves
		2.15. Running gear and steering greasing
		2.16. Suspension bracket and steering check
		2.17. Check карданного a shaft
		2.18. Exhaust system check
		2.19. Check and adjustment of a pedal of coupling
		2.20. Check of level of oil in a manual transmission
		2.21. Check of level of oil in a distributing box
		2.22. Check of level of oil and картередифференциала (or in a reducer of the back bridge)
		2.23. Shift of wheels
		2.24. Check of brakes
		2.25. Check of fuel system
		2.26. Check of the thermostat of the air filter
		2.27. Drive belts - check, adjustment and replacement
		2.28. Check of seat belts
		2.29. Replacement of the air filter and the ventilation filter картера
		2.30. Replacement of the fuel filter
		2.31. Filter replacement эжекционного the system valve доокисления exhaust gases
		2.32. Replacement of the filter of a tank with an absorber
		2.33. Check of fastening of the case throttle заслонки
		2.34. Check and adjustment of turns of idling (engines with fuel injection)
		2.35. Oil replacement in a distributing box
		2.36. Oil replacement in a manual transmission
		2.37. Oil replacement in a reducer back (or forward) the bridge
		2.38. Replacement трансмиссионной liquids! In automatic transmission
		2.39. Greasing replacement in naves of forward wheels and check of bearings (only for rear-wheel cars)
		2.40. Replacement of a cooling liquid
		2.41. Check and replacement of a zolotnik of ventilation картера
		2.42. Replacement свеч ignitions
		2.43. High-voltage wires - check and replacement
		2.44. A cover of the distributor and бегунок a rotor - check and replacement.
		2.45. Check and installation of the moment of ignition.
		2.46. The oxygen gauge
	3. Четырехцилиндровыв engines
	4. Engines VS
	5. All engines
	6. Systems of cooling, heating, ventilation and air-conditioning
	7. Fuel and exhaust systems
	8. System of an electric equipment of the engine
	9. System of decrease in toxicity of exhaust gases
	10. A mechanical transmission
	11. Automatic transmissions
	12. Coupling карданный a shaft and the back bridge
	13. A running gear of cars with the wheel formula 4x4
	14. Brake system
	15. Suspension brackets and a steering
	16. A body and furnish elements
	17. Electric equipment system

2-44-kryshka-raspredelitelya-i-begunok-rotora-proverka-i-zamena.html

2.44. A cover of the distributor and бегунок a rotor - check and replacement.

Attention!

The distributor cover is recommended to be changed together with candles.

44.1 Screws of a cover of the distributor

1. Disconnect a wire of the coil of ignition, turn away screws (or disconnect latches) and uncover (photo). Cautiously take a cover aside.

2. Check up a condition бегунка (photo). At detection of any defects бегунок replace, for what remove it from a rotor (or turn away a bolt) and establish new (photo).

44.2 Characteristic damages бегунка the distributor

1. Loss of elasticity of spring contact

2. Трешины

3. Damage because of задевания for a cover.

4. Corrosion

44.3 On engines late выпускав бегунок fastens a bolt

44.4 Characteristic damages of a cover of the distributor

1. Скоп nests under a wire

2. Erosion of conclusions

3. Deterioration of a piece of coal

4,5. A breakdown trace

6. Cracks

5. Establish a cover on and tighten screws.

3. Check up a condition of wires of the switchboard built in the distributor.

4. Examine a cover, check up presence from the interior of cracks, breakdown traces (thin burnt out, paths), and also deterioration, подгорания and easings of contacts (photo).При detection of the slightest signs of a doubtful condition a cover replace.

«The previous page
2.43. High-voltage wires - check and replacement

The following page»
2.45. Check and installation of the moment of ignition.