2-4-proverka-urovnya-zhidkostejj.html
2.4. Check of level of liquids1. Before check establish the car on an equal horizontal platform.
Oil in the engine
2. Oil level is checked щупом (photo).
3. Oil level is checked before driving on the car, or after approximately 15 minutes after an engine stop.
|
4.4г the Arrangement of marks on oil щупе
1. Normal level
2. Type And
3. Type In
4. On engines V6
5. On 4-cylinder engines
|
|
4.4б On 4-cylinder engines with 8 candles щуп it is located in the left back part of the engine
|
|
4.4в On engines V6 щуп it is located in a back part of the engine near to the amplifier of brakes
|
4. Get control щуп from a tube and wipe its pure rags or a paper napkin. Insert pure щуп against the stop into a branch pipe and again get. Level should be between marks L (minimum) and Н (maximum).
5. Support oil level only between the specified marks.
6. Oil add through a mouth on a cover of a head of cylinders (photo).
|
4.6 Stopper of a mouth on engine V6 is on the right cover of a head of cylinders
|
|
4.8 Broad tank of system of cooling
|
7. Attentively check up an oil condition on щупе. Emulsionnye pollution can be caused cracks in the block or in a head of cylinders, and also lining destruction, therefore it is necessary to check up an engine condition.
Cooling liquid
8. All cars considered in the given management, have system of cooling of an elevated pressure with return of a liquid to a broad tank (photo).
9. On the cold engine level should be between marks "MIN ' and"MOVE"on a broad tank On the heated-up engine level can be near to a mark"MOVE". If it is necessary to restore level wait engine cooling, uncover a broad tank and add a liquid of necessary structure antifreeze/water (it is recommended 50/50).
10. After a trip again check up level.
|
4.14 Tank стеклоомыватвля
|
11. Necessity frequent доливания specifies in infringement of tightness of system. Check up presence on a radiator, hoses and demountable connections of traces подтеканий in the form of stains, or увлажнений. If obvious signs of a leak it is not revealed, it is recommended to check up a radiator stopper, and tightness of all system a method опрессовки (pressure givings) on a car repair shop.
12. A stopper of a mouth of a radiator to turn on only on the cooled down engine.
13. At detection of traces of pollution wash out system and replace a liquid.
Liquid in a washer tank.
14. The tank стеклоомывателя is in a motor compartment from outside the driver (photo).
15. In a temperate climate in a tank стеклоомывателя pure water approximately on 2/3 tanks is filled in. In a frigid climate the liquid of special structure is filled in.
16. To prevent запотевание in cold weather, before inclusion смывателя warm up glass from a defreezing nozzle of a heater.
Check of level of electrolit
17. New cars are completed with batteries with the transparent case in which electrolit level is visible through the case (photo). If necessary add the distilled water.
Restoration of level of a liquid in a hydrodrive of brakes and couplings
18. The main cylinder of brakes and its tank are mounted on the vacuum amplifier in a motor compartment. The main cylinder of coupling is mounted on a partition of a motor compartment.
19. Liquid level should be between marks min and max on tanks (photo).
20. In a tank of brakes add only a liquid of the recommended mark, mixing of liquids of various marks is not supposed.
Attention!
The brake liquid has harmful influence on eyes and destroys a paint and varnish covering, therefore filling in a liquid be cautious. The brake liquid absorbs a moisture from air, therefore it is forbidden to fill in a liquid which was long time in open container in brakes. Surplus of a moisture leads to dangerous loss of efficiency of braking.
|
21. At detection of pollution it is necessary to merge and replace a liquid.
22. After restoration of level a tank stopper densely wrap.
|
4.17 Marks between which there should be an electrolit level
|
|
4.19а liquid Level should be in a tank of brakes about the top label
|
23. During normal work of system liquid level gradually goes down in process of deterioration of brake overlays. If frequent addition of a brake liquid in a system hydrodrive is available is required to flow, which should be eliminated immediately.
24. If level a liquid in tanks below norm it is necessary to remove air from a hydrodrive.
|