16-15-vnutrennyaya-panel-dveri-snyatie-i-ustanovka.html
16.15. The internal panel of a door - removal and installation1. Lower glass.
2. Turn away screws of fastening of an armrest to the panel.
3. Remove the handle стеклоподъемника for what the thin bent tool get a spring ring.
For this purpose wring out a decorative overlay to get access to a shaft and a spring ring, hook a ring and displace towards the handle, and remove a ring. Remove the handle and a plastic washer.
|
14.5 For removal of a guard of the handle turn away one screw
|
4. Remove the door-lock handle.
5. Remove a decorative guard of the handle doors (photo).
6. Hook a screw-driver and get latches of the panel from a skeleton doors (photo). To get latches begin from below and be displaced upwards, taking latches on a panel contour. Raise and remove the panel.
7. Before installation check up a condition of all for. лок also be convinced of correctness of orientation of a water filter.
8. Establish the panel, being guided on вставленно; коятке стеклоподъемника.
|
14.6 Latches of fastening of the internal panel of a door
|
|
15.7 Details of a door and стеклоподъемника
1. Door adjustment
2. Adjustment of position of a door loop
3. Adjustment of a forward trench
4. Mechanism adjustment стеклоподъемника
5. Adjustment of position of glass on стеклоподъемнике
6. Clamp adjustment
|
9. Insert latches to apertures of a skeleton of a door (by hand or a plastic hammer).
10. Further installation is carried out upside-down. Fix the handle стеклоподъемника a spring ring. For this purpose insert a spring ring into a groove on the handle so that ring rupture has been turned on 180 ° from the handle, expose the handle in parallel the handle on an opposite door and push a ring before click.
|