Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. The general data
14.3. Колодки disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement колодок
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See гл. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Колодки a manual brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. A hydrodrive highway - check and replacement
14.14. Prorolling of brakes
14.15. The vacuum amplifier of brakes - the general data and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. A manual brake - adjustment
14.18. The lever of a manual brake - removal and installation
14.19. Cables of a manual brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Antiblocking system (ABS) - the general data and access to codes.
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







14-7-kolesnyjj-cilindr-zadnikh-barabannykh-tormozov-snyatie-razborka-i-ustanovka.html

14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation

1. Prepare ремкомплект the cylinder.
2. Remove drums and колодки.
3. Substitute the pallet.

5.15 Back brake of the all-wheel drive car "Terrano I/Pathfinder" in gathering.


6.4 Union of a tube of a brake


4. Clear bolts of fastening of the cylinder to a board of a brake and the union (photo). Turn away the union and muffle a tube and an aperture in the cylinder.
5. Turn away 4 nuts of fastening of the cylinder and remove spring washers. Get the cylinder.
6. At dismantling remove covers, get heads of pistons and pistons. Remove from pistons cuffs (photo).
7. Check up a condition of details, presence of scratches on the cylinder because of pollution in a liquid.
8. If a cylinder condition satisfactory wash out its brake liquid.
9. Grease new cuffs with a liquid and establish on pistons so that edges of cuffs have been turned in the cylinder. Collect the cylinder.
10. The further assemblage is carried out upside-down. Pump over a hydrodrive of brakes and remove air.

6.6 It is put/m the wheel cylinder 1. A cover 2. Готта пщшшт Z.Parshvn 4. Cuffs 5. The cylinder 6. The union дпя prorolling 7. A cap



«The previous page
14.6. Back drum-type brakes - replacement колодок
The following page»
14.8. See гл. 1