Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. The general data
14.3. Колодки disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement колодок
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See гл. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Колодки a manual brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. A hydrodrive highway - check and replacement
14.14. Prorolling of brakes
14.15. The vacuum amplifier of brakes - the general data and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. A manual brake - adjustment
14.18. The lever of a manual brake - removal and installation
14.19. Cables of a manual brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Antiblocking system (ABS) - the general data and access to codes.
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







14-3-kolodki-diskovykh-perednikh-i-zadnikh-tormozov-zamena.html

14.3. Колодки disk (forward and back) brakes - replacement

Attention!
Колодки vary only in the complete set on one axis. At clearing колодок a dust and a dirt to delete wiping by rags moistened in spirit, it is forbidden to blow.

1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Turn away a bolt of the bottom axis of the cylinder (photo).
3. Cast away a support upwards (photo).
4. Remove holders, linings and колодки. Pay attention to an initial arrangement of details.
5. Grease contact surfaces of a support with silicone greasing (photo).
6. Establish new internal колодки and linings.
7. Lower a support and displace outside of (photo).
8. Again lift a support and establish new external колодки and linings (photo).
E.Opustite a support also tighten a bolt of an axis with the set moment.
10. The further operations are carried out upside-down. Check up liquid level if necessary restore. Check up work of brakes.


«The previous page
14.2. The general data
The following page»
14.4. A brake support - removal, dismantling and installation