Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. The general data
14.3. Колодки disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement колодок
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See гл. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Колодки a manual brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. A hydrodrive highway - check and replacement
14.14. Prorolling of brakes
14.15. The vacuum amplifier of brakes - the general data and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. A manual brake - adjustment
14.18. The lever of a manual brake - removal and installation
14.19. Cables of a manual brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Antiblocking system (ABS) - the general data and access to codes.
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







14-19-trosy-ruchnogo-tormoza-snyatie-i-ustanovka.html

14.19. Cables of a manual brake - removal and installation

Forward cable
1. Release the brake lever.
2. Disconnect a cable from the lever (photo).
3. If necessary lift a back part of an auto-mobile and establish on supports.
4. Turn away a nut and disconnect the opposite end of a cable from the levelling lever (on all-wheel drive а/м) or from a regulator (on rear-wheel а/м).
5. Disconnect a back left cable from the forward.
6. Turn away bolts of the levelling lever.
7. Disconnect all collars and remove a forward cable and the levelling lever.
8. Installation is carried out upside-down. Grease all rubbing details.

18.2 Details of a drive of a manual brake of the car "Terrano I/Pathfinder" 1. A back cable 2. A regulator 3. A forward cable


Back cable
9. Release the brake lever.
10. Turn away a nut and disconnect a cable from the levelling lever (on all-wheel drive а/м) or from a regulator (on rear-wheel а/м).
11. Disconnect a back left cable from the forward.
12. Disconnect tips of a back cable from back brakes and get tips through apertures in a brake board.
13. Ослабьте collars also remove cables.
14. Installation is carried out upside-down. Grease all rubbing details.

«The previous page
14.18. The lever of a manual brake - removal and installation
The following page»
14.20. The switch of a signal of braking - removal and installation