Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. The general data
14.3. Колодки disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement колодок
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See гл. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Колодки a manual brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. A hydrodrive highway - check and replacement
14.14. Prorolling of brakes
14.15. The vacuum amplifier of brakes - the general data and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. A manual brake - adjustment
14.18. The lever of a manual brake - removal and installation
14.19. Cables of a manual brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Antiblocking system (ABS) - the general data and access to codes.
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







14-16-vakuumnyjj-usilitel-tormozov-snyatie-i-ustanovka.html

14.16. The vacuum amplifier of brakes - removal and installation

1. Remove the main cylinder.
2. Disconnect a hose.
3. Disconnect a rod of the amplifier from a brake pedal, having removed an axis (photo).
4. Turn away 4 nuts and get the amplifier from outside a motor compartment.
5. Installation is carried out upside-down. Before cylinder installation check up the sizes And and In (photo), if necessary adjust. If at adjustment the size And has changed more than on 0,5 mm the amplifier replace because of its wear-out.

15.3 Vacuum amplifier 1. An axis of a pedal 2. The amplifier


15.5 Before cylinder installation check up the sizes And and In (photo), if necessary adjust (on a part of cars, - Specifications) see


6. Pump over brakes.
7. Check up height and a pedal free wheeling (Gl. 1)


«The previous page
14.15. The vacuum amplifier of brakes - the general data and check
The following page»
14.17. A manual brake - adjustment