Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
13. A running gear of cars with the wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. The general data
14.3. Колодки disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement колодок
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See гл. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Колодки a manual brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. A hydrodrive highway - check and replacement
14.14. Prorolling of brakes
14.15. The vacuum amplifier of brakes - the general data and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. A manual brake - adjustment
14.18. The lever of a manual brake - removal and installation
14.19. Cables of a manual brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Antiblocking system (ABS) - the general data and access to codes.
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







14-14-prokachka-tormozov.html

14.14. Prorolling of brakes

Attention!
Before prorolling of brakes on the cars equipped ABS - system disconnect the battery from weight. To pump over brakes it is recommended together.

1. Necessity of prorolling arises after replacement of details of a highway of a hydrodrive. At dismantling of a hydrodrive of one wheel it is possible to be limited to prorolling only an understanding contour.
2. Lift the car and establish on supports. Press some times a brake pedal. Before prorolling restore liquid level in a tank and during prorolling support level, without supposing a tank devastation.
3. Begin prorolling with a pressure regulator. Turn on it is hard tighten the union for prorolling (photo).
4. Attach to the union a hose, other end of a hose lower in a vessel with a brake liquid.
5. Ask the assistant to press some times grief of a brake and to keep. Turn away the union and later 2 сек after a stream of a liquid following with bubbles ослабнет, tighten the union. Ask the assistant to release a pedal.
6. Repeat procedure of 8-9 times, until then while in a following liquid vials will not cease to be observed. Tighten the union.
8. Execute these actions on wheel cylinders in sequence: right back wheels, the left back, right forward, left forward. Upon termination of restore liquid level in a tank.


«The previous page
14.13. A hydrodrive highway - check and replacement
The following page»
14.15. The vacuum amplifier of brakes - the general data and check