|
13-9-salniki-perednego-reduktora-zamena.html
13.9. Epiploons of a forward reducer - replacementEpiploon of a leading gear wheel of the main transfer
1. Merge oil from картера a reducer
2. Lift redock of the car and establish on supports.
3. Disconnect from a flange of a forward reducer карданный a shaft.
4. Turn away a nut of a reducer (photo), having screwed bolts in a flange and having rested a screw-driver.
5. Press a flange of a reducer (photo).
6. Hook and accurately get an epiploon.
7. Put in an epiploon universal greasing and запрессуйте in картер оправкой.
8. Dress a flange, turn and tighten a nut of a reducer with the set moment.
9. With the help динамометрического a key with a scale on some Н.м. Check up the resistance moment проворачиванию a leading gear wheel of a reducer, having turned for a nut clockwise. The moment is equal to a preliminary tightness in bearings. If the moment is less than norm tighten a nut. If the moment exceeds norm распорная the plug of bearings will be damaged, a reducer it is necessary to disassemble and replace the plug.
|
|
8.5 Removal of a flange from a leading gear wheel of the main transfer
|
|
|
8.12 Removal of a flange of a semiaxis
|
10. Other operations are carried out upside-down.
Epiploon of the left semiaxis
11. Remove полуось.
12. Remove a semiaxis flange, having hooked two screw-drivers (photo).
13. Get an epiploon.
14. Запрессуйте a new epiploon.
15. Put in an epiploon universal greasing and запрессуйте in картер оправкой.
16. Establish a flange and полуось.
The right epiploon
17. Turn away 4 bolts of fastening of the case of the bearing and the right shaft of a reducer (photo).
18. Clamp полуось in a vice, having laid wooden бруски.
19. Cautiously cut down the plug from a shaft (photo).
|
|
8.17 Details of the right part of a forward reducer 1. An adjusting lining 2. The case of the bearing 3. An epiploon 4. A ring 5. The right shaft 6. The bearing 7. The plug 8. The case
|
|
|
8.19 Removal of the plug of the bearing from the right shaft
|
|
|
8.21 Vypressovka of a shaft 1. The plug is removed
|
|
|
9.6 Bolts of fastening of a forward reducer
|
|
|
9.8 Bolts of fastening of a reducer to a frame.
|
20. Turn away 4 bolts and remove from a reducer the case of the right shaft.
21. Establish полуось in the case, tighten the case of the bearing and выпрессуйте a shaft from the bearing (photo).
22. Hook and get an epiploon from the bearing case. Запрессуйте a new epiploon blows through брусок.
23. Remove the case of the bearing and dress on a shaft. Dress the new plug. Запрессуйте a shaft in the case (it is recommended to execute in car-care centre).
24. Other operations are carried out upside-down.
|