Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-9-vyzhimnojj-podshipnik-zamena.html

12.9. The vyzhimnoj bearing - replacement

1. At repair or replacement of details of coupling it is necessary to replace выжимной the bearing, or to perform works on its service.
2. If the exit of greasing from the bearing is observed, or the bearing is hardly turned by hand it is necessary to replace it.
3. Remove a rubber cover of a plug of coupling.
4. Disconnect a screw-driver a spring of a spherical support plugs (photo).
5. Remove a plug of deenergizing of coupling.
6. Remove выжимной the bearing (photo).

Attention!
Check up presence on a plug of cracks and deformations. Check up freedom of rotation of the bearing by hand. The vyzhimnoj bearing cannot be washed out and in solvent. At installation of new coupling выжимной it is necessary to replace the bearing.

7. If necessary press выжимной the bearing about naves (photo).

8.7 Vypressovyvanie выжимного the bearing from a nave


8.9 Put greasing in an internal cavity of a nave, grease the places specified by arrows 1. To put greasing


9.5 Removal of the directing plug by a special stripper


8. Запрессуйте the new bearing, putting effort to an external holder.
9. Assemblage is carried out upside-down. Put refractory greasing in an internal cavity naves (photo).
10. Apply a thin film the same greasing on rubbing surfaces of a plug. Superfluous greasing is not supposed
11. At plug installation on выжимной the bearing be convinced that the spring terminations have come in проточку the bearing and rest against a plug (photo).

9.6 Removal of the directing plug by hydroblow


8.11 Fixing выжимного the bearing a spring on a plug of deenergizing of coupling



«The previous page
12.8. Details of the mechanism of coupling - removal, dismantling and installation
The following page»
12.10. The directing plug of a primary shaft of a check point - replacement