Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-7-gidroprivod-scepleniya-udalenie.html

12.7. A coupling hydrodrive - removal

1. System prorolling is required every time after carrying out of dismantling and assemblage of a hydrodrive of coupling.
2. Запол-fwre a tank a fresh brake liquid (use of the fulfilled liquid is forbidden).
3. First of all it is necessary to remove air from демпферного the cylinder.
4. Dress on the union of the cylinder a hose and release in the capacity filled with a brake liquid on 3-5 see
5. Turn away the prorolling union on 1/2 turns and ask the assistant to press a coupling pedal to the full. Tighten the union, ask the assistant to release a pedal slowly. Repeat procedure until then while the hose will not cease to leave air vials.

7.8 Check of deformation of petals of diafragmen th spring


7.6 Removal of coupling


6. After two, three times of pressing a pedal check up liquid level. Constantly watch level, the tank should be completely filled by a liquid.
7. At the pressed pedal tighten the union (do not tighten too strongly), remove a hose, restore liquid level in a tank. Execute the same operations for the main cylinder of coupling.

«The previous page
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
The following page»
12.8. Details of the mechanism of coupling - removal, dismantling and installation