Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-6-dempfernyjj-cilindr-scepleniya-snyatie-razborka-i-ustanovka.html

12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation

Removal
1. Disconnect from the cylinder of the union of tubes of a hydrodrive (photo), muffle tubes.
2. Turn out two screws and remove the cylinder.
Dismantling
3. Turn away bolts and uncover, get other details (photo).

7.5 Order отпускания coupling bolts


4. Wash out all details in a pure brake liquid.
5. Check up a condition of an internal surface of the cylinder. At detection of corrosion or scratches the cylinder replace.
6. Check up a backlash between the cylinder and the piston. If the backlash exceeds 0,15 mm replace the piston or the cylinder, having picked up details so that the backlash corresponded to norm.
7. At assemblage, moisten the piston and the cylinder with a pure brake liquid. Track correctness of installation of all rubber details.
Installation
8. Establish the cylinder upside-down.
9. Pump over a coupling hydrodrive (see more low).
10. Adjust height and a pedal free wheeling. (Gl. 1)

«The previous page
12.5. The working cylinder of coupling - removal, dismantling and installation
The following page»
12.7. A coupling hydrodrive - removal