Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-3-pedal-scepleniya-snyatie-ustanovka-i-regulirovka.html

12.3. A coupling pedal - removal, installation and adjustment

Removal
1. Disconnect a pusher of the main cylinder from a pedal.
2. Turn out from an arm the terminator of a pedal or the gauge of deenergizing of coupling.
3. Turn away a nut and remove an axis pedals (photo).
4. A returning spring
5. The gauge of deenergizing of coupling
6. Switch ASCD (control cruise)
7. Сервопружина
8. A pedal
4. Remove a pedal and a spring:
5. Wash out details in solvent and replace those which are worn strongly out or damaged. The plug запрессована in a pedal, therefore in case of the strengthened deterioration of the plug varies all pedal.
Installation
6. Installation is carried out upside-down.

2.6 At pedal installation grease the specified places 1. To grease


3.3 Main cylinder fastens to a partition of a motor compartment


Attention!
Grease консистентной with greasing a pedal axis, a persistent platform, сервопружину and a pin of a pusher of the main cylinder (photo)

Adjustment
7. After installation check up height and a pedal free wheeling. If necessary adjust, having executed operations described in Chapter 1.

«The previous page
12.2. Coupling - the general data
The following page»
12.4. The main cylinder of coupling - removal, dismantling and installation