Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-18-zadnijj-most-snyatie-i-ustanovka.html

12.18. The back bridge - removal and installation

Removal
1. Lift a back part of the car and establish supports under a body.
2. Prop up the cart with a jack the back bridge under картер a reducer.
3. Remove wheels.
4. Disconnect from a reducer карданный a shaft.
5. Disconnect a cable of a manual brake and a highway of a hydrodrive of brakes (Gl. 10).
6. Turn away the bottom nuts of fastening of both shock-absorbers and compress shock-absorbers.
7. Disconnect from a body of draught of the stabilizer (Гл.11).
8. Disconnect the top and bottom longitudinal bars.
9. Disconnect from the back bridge a cross-section bar (Гл.11).
10. Cautiously lower the back bridge and will remove springs (procedure of removal and installation of springs is described in Gl. 11).
Installation
11. If it is supposed to replace a beam of the back bridge remove back brakes in gathering, semiaxes and a reducer and rearrange all details on a new beam
12. Bridge installation is carried out upside-down.
13. Pump over brakes (Gl. 10).

«The previous page
12.17. An epiploon of a leading gear wheel of a reducer - replacement
The following page»
13. A running gear of cars with the wheel formula 4x4