Nissan Terrano 2 with 1985 on 1999
1. The maintenance instruction and to maintenance service
2. Car maintenance service
3. Четырехцилиндровыв engines
4. Engines VS
5. All engines
6. Systems of cooling, heating, ventilation and air-conditioning
7. Fuel and exhaust systems
8. System of an electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. A mechanical transmission
11. Automatic transmissions
12. Coupling карданный a shaft and the back bridge
12.1. Specifications
12.2. Coupling - the general data
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The dempfernyj cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydrodrive - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. The vyzhimnoj bearing - replacement
12.10. The directing plug of a primary shaft of a check point - replacement
12.11. A kardannyj shaft, a reducer and the back bridge - the general data
12.12. Карданный
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. The back bridge - removal and installation
13. A running gear of cars with the wheel formula 4x4
14. Brake system
15. Suspension brackets and a steering
16. A body and furnish elements
17. Electric equipment system
 







12-14-kardannye-sharniry-zamena.html

12.14. Kardannye hinges - replacement

Attention!
Kardannye hinges on a part of cars are not subject to replacement. Before dismantling карданного a shaft consult at the supplier of spare parts.

Lock rings of bearings крестовин are picked up for a thickness. Not to break balancing карданного a shaft new lock rings крестовин should be precisely same thickness, as replaced ("Specifications" see)

13.2 to remove a lock ring, beat out егс hammer blows on a screw-driver


13.3 Vypressovyvanie of bearings крестовины


14.6а Poluos and the back bridge 1. An epiploon 2. A nut of the wheel bearing 3. A lock washer of the wheel bearing 4. A washer 5. The wheel bearing 6. The dividing plug 7. A holder of the bearing 8. An epiploon 9. Полуось 10. A refuelling aperture 11. Сапун 12. Сливн


13.6 Installation of lock rings


1. Designate a relative positioning of all details of hinges.
2. Clear a plug of a dirt and get lock rings (photo).
3. Beat out bearings крестовин blows of a hammer with soft brisk on a plug (photo).
4. Get крестовину.
5. Check up люфт bearings in necks крестовин, the worn out details replace.
6. Assemblage is carried out upside-down.

Attention!
Before installation grease lock rings консистентной with greasing Establish lock rings on former places (photo), considering that the thickness of lock rings opposite bearings should not differ more than on 0,06 mm.


«The previous page
12.13. An average support - replacement
The following page»
12.15. Полуось, the back wheel bearing and an epiploon - removal and installation.